PRODUCTS LIST

Gate valve
Butterfly valve
Ball valve
Globe Valve
Check valve
Control valve
Water Meter
Air valve
Copper valve
Pipe Repair & Coupling
Ductile iron(DI) pipe fittings
Strainer
Dismantling Joint

What is an angle valve?

2023-07-03
What is an angle valve?

Concept: Angle valve is also called triangle valve, Angle valve, folding Angle water valve, mostly used for the decoration industry of water and electricity installation, is an important plumbing accessories.

Uses of angle valves:

(1)Starting with the internal and external water outlet;

(2)The water pressure is too large, it can be adjusted above the triangle valve, close a little bit;

(3)The role of the switch, if the faucet water leakage and other phenomena occur, you can turn off the triangle valve, do not have to close the total valve in the home;

elegant appearance. So, the general new house decoration is essential plumbing accessories, so the new house designer will be mentioned.

Features of angle valves:

(1)The flow path is simple, the dead area and the vortex area is small, with the help of the medium itself, can effectively prevent the medium blockage, that is, have good self-cleaning performance;

(2)The flow resistance is small, the flow coefficient is larger than the single seat valve, equivalent to the flow coefficient of the double seat valve;

(3)It is suitable for high viscosity, containing suspended matter and granular fluids, or where right-angle piping is required.

Installation methods of angle valves:

(1)Before installation, confirm that the product surface is sand-free, the thread tube wall thickness is uniform, and the switch rotation is flexible. Before installation, the water pipe should be dredged once to confirm that there is no garbage and residue in the water pipe, so as not to affect the water supply.

(2)Pay attention to the winding direction, take the Angle valve as an example, the Angle valve in the wall into the wall, is clockwise to the right clockwise rotation, that we in the direction of the Angle valve with the material is to the left counterclockwise winding, so that the Angle valve will be more tight, will not loose.

(3)When wrapped to pull the raw material belt, so that the raw material belt closely attached to the thread, as tight as possible, do not wrap loose, wrapped to use the hand ring pressure, can also be pressed while wrapping.

(4)As for the winding "several layers", there is no rigid provisions, to tighten, no leakage shall prevail, but according to experience, usually need to wrap more than ten laps to ensure sealing.

(5)When the screw thread do not twist to the dead, by the point of strength, do not have to twist to really twist is not to leak, as long as the screw feel can eat the strength can be  also pay attention to the depth of the twist in.